Made in Taiwan
Sometimes you need just a little more than 4ft roll forming material. This is where the PR-609 shines. The PR-609 sheet metal roller has a
maximum 6ft forming width, which can roll up to 9 gauge mild sheet steel. All functions of this machine are hydraulically controlled for increased durability, reliability and efficiency. The
industrial grade hydraulic system is run off of a 3 hp 220 volt three phase motor. This is more than enough to handle the 9 gauge capacity all day long. The back roll on the PR-609
sheet metal roller is also controlled by the hydraulic system and has a digital position indicator, so the operator knows exactly where the roll is at all times.
The PR-609 is built to last like all Baileigh Industrial sheet metal rollers. It has a fully integrated plate steel frame. This setup keeps the forming
rolls perfectly in alignment during the bending process. The PR-609s top roll has a very simple release mechanism to release work that has been wrapped around the top roll.
The PR-609 also has a foot pedestal to control some bending functions; forward, reverse, up, and down. For operator safety we have included dual emergency stop
cables that are located on both the back and front of the machine. For more information on the PR-609, contact a representative today.
-
