-
Push the Powder Comb perpendicularly into the dry powder so that the two stand-offs (end tabs) on both sides of the teeth rest firmly
on the substrate.
-
Drag the Powder Comb along the surface of the coated part for at least 1 centimeter.
-
Remove the Powder Comb from the surface and examine the marks left in the powder.The powder thickness is between the highest numbered
tooth which made a mark and has powder clinging to it, and the next highest tooth which left no mark and has no powder clinging to it.
Example: The 75 and 150 micron teeth both make lines and have powder clinging to them but the 225 mil tooth does not. The uncured powder thickness
is determined to be between 150 and 225 microns. (see above image)
Note - Most powders cure to approximately 50% of their dry thickness. Marks left by the gage may affect the characteristics of the
cured film.
