This is the easiest, most economical way to produce low production metal and plastic profiles. Trace-A-Punch follows your guided template to produce burr free
straight and contoured outlines and holes. Simple, rugged meehanite casting construction insures very little maintenance.
An existing part can be used as the master pattern or one can easily be made by tracing over acetate-plastic .020-1/2 inch with a sharp scriber or razor knife. An office copier can be used to
produce a master by copying on to Mylar-plastic and cutting with scissors.
All Trave-A-Punch comes complete rerady to run with one #031 (.312) M2 Punch and Die Set,two material clamps, work light, wrenches and Instructions
