Dry Cutting: 10" Abrasive Mitering Cutoff
10" Abrasive Mitering Cutoff Catalog Page
Complete with 3 HP TEFC motor and swivel vise
Fast, Low Cost Cutting of Hardened Tool Steel, Drills, Reamers,
Bars, Pipe, Angle Iron, Tubing, Flat Stock & Rod.
Capacity: 1.5" solid; 2" pipe
(10" miter saw only most 1.75" shapes at 45 degrees)
Mitering work back stop and vise jaw adjust to cut any miter up to 45 deg. Calibrated scale to locate proper position for vise rear fence. Vise jaw automatically adjusts.
Mitering work back stop and vise jaw adjust to cut any miter up to 45 deg. Calibrated scale to locate vise rear fence.
Use a steel blade (see options below) to cut plastic, and with an oiler to cut aluminum, copper and nonferrous material.
Abrasive Wheels: Dry Reinforced Abrasive Cutting Wheels
Link for Everett Dry Cut Abrasive Blades
All the cutting wheel grades have been developed and extensively tested to produce quality
cuts on a wide range of material alloys, sizes and shapes.
As a manufacturer of abrasive wheels, we have other grades of wet and dry abrasive wheels to meet your specific requirements. Contact us for special diameter, thickness, arbor hole and drive pin
requirements of abrasive wheels.
Fiberglass Internally Reinforced Resinoid Bond Aluminum Oxide Cutting Wheels
Woven fiberglass cloth is molded in the center of the abrasive wheel for break resistance.
|
Grade
|
|
Description of Cutting Wheels
|
|
|
45FG
|
|
For general purpose cutting
|
|
|
|
|
|
|
|
23020FG
|
|
Designed for use on machines with POWERHEAD (automatic wheel feed) where free cutting ability is needed because of constant feed pressure
|
|
|
|
|
|
|
|
2069FG
|
|
Ideal for heavier wall shapes and tubing
|
|
|
|
|
|
|
|
T32 FG
|
|
For cutting thin wall shapes and thin wall tubing
|
|
|
|
|
|
|
|
GTK-7FG
|
|
Excellent for high quality dry cuts on stainless tubing and other thin wall tubing
|
|
Fiberglass Externally Reinforced Cutting Wheels
Woven fiberglass cloth is applied externally on both sides of the abrasive wheel for break resistance.
|
Grade
|
|
Description of Cutting Wheels
|
|
|
45FGE
|
|
For general purpose cutting
|
|
|
|
|
|
|
|
23020FGE
|
|
Designed for use on cutoff saws with POWERHEAD (automatic
wheel feed) where free cutting ability is needed because of constant feed pressure
|
|
|
|
|
|
|
|
2069FGE
|
|
Ideal for heavier wall shapes and tubing
|
|
|
|
|
|
|
|
T32 FGE
|
|
For cutting thin wall shapes and thin wall tubing
|
|
|
|
|
|
|
|
GTK-7FGE
|
|
Excellent for high quality dry cuts on stainless tubing and other thin wall tubing
|
